Odroid C0 Connector Pack

This is a perfect connector pack for various DIY projects with the ODROID-C0.
You need a soldering skill to use this pack.

Most of connectors are identical to the ODROID-C1+.

There are two different USB host connectors in this package.
If you want to make a lower profile board, use a single layer connector.
If you want to make a full connectivity, use a dual layer connector.
 

PACKAGE INCLUDE A. Double Layer USB Type-A 8-Pin DIP Jack Connector  B. Single Layer USB Type-A 4-Pin DIP Jack Connector C. IR(InfraRed) Receiver Sensor This is a remote control receiver module that can accept standard 37.9Khz carrier frequency based wireless data. D. UART Console Connector Molex 5268-04a(2.5mm pitch) is mounted on the PCB.  Its mate is Molex 50-37-5043 Wire-to-Board Crimp Housing. E. 7-pin Strip Male Header  Add pins to the audio I2S interface holes in the ODROID-C0.  2.54mm(0.1inch) pitch F. 20x2-pin Strip Male Header Add pins to the 40pin GPIO port.  2.54mm(0.1inch) pitch