• Tüm Kategoriler
    • US-100 Ultrasonik Mesafe Sensörü

      Görsel 1
      Görsel 2
      Görsel 3
      DomiPuan : 60
      Fiyat:
      5,46 USD + KDV
      İndirimli Fiyat (%13,9) :
      4,70 USD + KDV
      Kazancınız 0,76 USD
      KDV Dahil:
      70,64 TL
      5.0 1
      10,94 TL'den başlayan taksit seçenekleri için tıklayın.
      Aynı Gün Kargo

       

      AÇIKLAMA




      2cm ile 400cm arası 3mm hassasiyetle ölçüm yapabilen bu ultrasonik sensör çeşitli uzaklık okuma, radar ve robot uygulamalarında kullanılabilir. 


       

      ÖZELLİKLER


       

      > Çalışma Voltajı: DC 5V
      > Çektiği Akım: 15 mA
      > Çalışma Frekansı: 40 Hz
      > Maksimum Görme Menzili: 4m
      > Minimum Görme Menzili: 2cm
      > Görme Açısı: 15 0
      > Tetik Bacağı Giriş Sinyali: 10 us TTL Darbesi
      > Echo Çıkış Sinyali Giriş TTL sinyali ve Mesafe Oranı





      -----------------------------------------------------------------------------------

      The US-100 Ultrasonic Distance Sensor Module operates from a wide voltage range and provides both digital and serial data output modes.

      The US-100 features accurate temperature corrected range detection. It can output the distance in millimeters using a serial data output mode. Alternatively, the distance can be calculated by measuring the amount of time that a digital output is held high.

      This sensor can be used with both 3.3V and 5V microcontrollers and only consumes 2mA when idle.


      Using the US-100 Ultrasonic Distance Sensor Module

       

      Connect the VCC and GND pins to a 2.4V-5.5V power supply. The usage of the other pins depends on the operating mode selected. Select the operating mode of the US-100 Ultrasonic Distance Sensor by using the jumper on the back of the module. When the jumper is present, the sensor outputs the distance as binary serial data, otherwise the sensor outputs a single pulse that has a width which represents the distance measured.


      Using the US-100 Distance Sensor in Serial Data Mode

       

      Place the shunt on the operating mode selection jumper to choose serial data mode. Attach the module to a serial port on your microcontroller. The Trig/TX pin connects to your microcontroller's TX serial transmit line. The Echo/RX pin connects to your microcontroller's RX serial receive line. Set the microcontroller's serial port to use 9600 baud at 8-N-1 (eight data bits, no parity, one stop bit).

      To start measuring the distance, output a 0x55 over the serial port and read back the two byte distance in high byte, low byte format. The distance returned is measured in millimeters. Use the following formula to obtain the distance as millimeters:

      • Millimeters = FirstByteRead * 256 + SecondByteRead

      This module can also output the temperature when using serial output mode. To read the temperature, output a 0x50 byte over the serial port and read back a single temperature byte. The actual temperature is obtained by using the following formula:

      • Celsius = ByteRead - 45


      Using the US-100 Sensor in Pulse Width Mode

       

      Select the pulse mode by removing the shunt from the operating mode selection jumper. Connect the Trig/TX pin to a digital output on your microcontroller and the Echo/RX pin to a digital input.

      To obtain a distance measurement, set the Trig/TX pin high for at least 50 microseconds then set it low to trigger the measurement. The module will output a high pulse on the Echo/RX line with a width that corresponds to the distance measured. Use your microcontroller to measure the pulse width using microseconds. Use the following formula to calculate the distance:

      • Millimeters = PulseWidth * 34 / 100 / 2
      Diğer Özellikler
      Stok KoduSEN-01116
      MarkadomiRobot
      Stok DurumuVar

      İlginizi Çekebilecek Diğer Ürünler


       
      Bizi Takip Edin DomiRobot Müşteri Hizmetleri Hızlı Erişim  
      Twitter Hakkımızda Ödeme Seçenekleri Anasayfa  
            


       
      Facebook İletişim Bilgileri Kargo/Teslimat Hakkında Yeni Ürünler
      YouTube Banka Hesapları Kullanım Şartları İndirimdekiler
      Telegram  DomiPuan Sistemi Gizlilik Politikası Sepetim
          Üye Giriş/Yeni Üye İade ve Garanti Şartları Download
               
        

      PlatinMarket® E-Ticaret Sistemi İle Hazırlanmıştır.