JustBoom Amp HAT - Raspberry Pi uyumlu

AÇIKLAMA

ÖZELLİKLER

• Yüksek kalite ses - 192kHz/32-bit
• 2x55 watt tepe çıkışı, 8 ohm (2x30 watt RMS)
• DAC ve güç yükselticisi içerir - pasif hoparlörünüze bağlayınız
• Raspberry Pi a geri güç sağlar, bu sayede tek güç kaynağı ile tüm sistem çalışır. 2.5 A ile besler.
• Tak-Çalıştır
• Raspberry Pi üzerinden donanım ve yazılım ses kontrolü
• IR içerir
• Lehim gerektirmez
• Boştaki Raspberry Pi GPIO pinleri pin uzatma header ları ile erişilebilir
• Raspbian / NOOBS için tam sürücü desteği
• OSMC / Max2Play / RuneAudio / Volumio / Moode / PiCorePlayer / PiMusicBox / OpenELEC vb uyumlu
• Dahili donanım jumperları ile ses kapa ve kazanç ayarları yapılabilir

• Başlangıç Rehberi
• JustBoom Eğitimi
• Yazılım Rehberi
• JustBoom Pin Şeması

JustBoom designed the Amp HAT to be simple to install and use. With no soldering required and all the mounting hardware already provided, this product is suitable for both beginners and seasoned professionals alike. Just connect your Amp HAT to a set of passive speakers, and you can be up and running quickly, enjoying flawless, high-quality audio playback within minutes. Also included is an optional IR receiver to allow remote control operation of your Raspberry Pi Amplifier.

Featuring a Class-D power amplifier chip with built-in 192kHz/32-bit DAC, for a peak power output of 2 x 55 watts, the JustBoom Amp HAT outputs audio over two speaker cable connector blocks that accept anything up to 14 AWG cable and will provide crystal-clear audio to either 4 or 8 ohm passive speakers. The Amp HAT uses the I2S interface for its audio input, which reduces CPU load on the Raspberry Pi compared with USB solutions. It is also designed to back-power the Raspberry Pi over the 40-pin GPIO header, meaning you only need a single power supply for the entire system.

• Full high-quality audio — 192kHz / 32-bit
• 2 x 55 watt peak output at 8 ohms (2 x 30 watt RMS)
• Includes both a DAC and power amplifier — just connect to your passive speakers
• Back-powers the Raspberry Pi over the GPIO (with full HAT-compliant protection) at 2.5A, so only one power supply is required for the whole system.
• Plug-and-play compatibility for ease of use
• Hardware and software volume control from your Raspberry Pi
• Onboard hardware jumpers for configuring mute and gain settings (jumpers could optionally be changed with switches)
• Mute/enable with GPIO22 (this can be overridden by using jumper J4)
• No soldering required
• Optional IR receiver included in package
• Unused GPIO pins still accessible via unpopulated extension header
• Full driver support in Raspbian / NOOBS
• Compatible with OSMC / Max2Play /RuneAudio / Volumio / Moode / PiCorePlayer / PiMusicBox / OpenELEC and others